aaron at wholesaleinternet
May 29, 2012, 7:31 PM
telnet issue on multiple Foundry switches
I'm having a strange issue when I try to telnet into a few of my foundry
switches. The switches will refuse the connections.
I originally had this issue with two 4802s. I thought the problem was due
to bad switchs but then the issue popped up on an MG8 and an RX4.
If I stop and restart the telnet service from the console they will accept
telnet connections for about 5 minutes, then start refusing them again.
show telnet shows no active sessions and the CPUs are not overloaded. Logs
Has anyone experienced this before and knows a solution? Is this a known
issue I need to look out for? Any advise is appreciated.
foundry-nsp mailing list
foundry-nsp [at] puck