linux.yahoo at gmail
Jul 15, 2009, 1:12 AM
Post #2 of 2
(616 views)
Permalink
|
address-based only with this release/configuration
On Tue, Jul 14, 2009 at 2:49 PM, Marcin Kuczera <marcin[at]leon.pl> wrote:
> hello,
>
> I'am just testing sharing in Summit400-48t and... there is only dynamic
> algorythm that sais:
> * Summit400-48t:16 # enable sharing 47 grouping 47,48 a
> Next possible completions:
> <cr>
>
> * Summit400-48t:16 # enable sharing 47 grouping 47,48 algorithm
> address-based
>
> * Summit400-48t:17 # show ports 47 info detail
> Port 47:
> Type: UTP
> Diagnostic: passed
> Admin state: Enabled, with auto-duplex auto-speed sensing
> Link state: Active. Full-duplex 1000 Mbps.
> Link counter: Up 6 time(s), Down 5 times(s)
> Link Filter counter: Up 6 time(s), Down 5 times(s)
> VLAN cfg:
> test [802.1Q Tag=0100,Mac-Limit:Cfg=No-limit,LRN=37,BlkHole=0]
>
> STP cfg:
> s0(enable), Tag=(none), Mode=802.1D, State=FORWARDING
>
> Trunking: Master port with 2 members using address-based
> algorithm
> Members: 47 48 [Current runtime master is 47]
>
> well, if I set "dynamic" it is still address-based.
>
> Will that allways be address based or can automatically switch to
> round-robin if the link is quite loaded ?
> Or this switch can do only address based ?
>
> In Alpine I could pick up round-robin method :(
>
> Regards,
> Marcin
> _______________________________________________
> extreme-nsp mailing list
> extreme-nsp[at]puck.nether.net
> https://puck.nether.net/mailman/listinfo/extreme-nsp
>
|
