gasiu at konto
Mar 21, 2008, 10:07 AM
Post #1 of 2
(1408 views)
Permalink
|
|
Multiproto patch for 0.21 and SkystarHD
|
|
Where can I find working Multiproto patch for MythTv0.21 and SkystarHD?
With this one:
http://www.linuxtv.org/pipermail/linux-dvb/attachments/20080107/9b8959a2/attachment.bin
patching without problems, but in mythtv-setup, when I try to tune,
MythTV Setup Terminal shows:
>DVBSM(0), Error: Can not read DVB status eno: Invalid argument (22)
>DVBSM(0), Warning: Can not measure Signal Strength eno: Invalid
argument (22)
>DVBSM(0), Warning: Can not meassure S/N eno: Invalid argument (22)
>DVBSM(0), Warning: Can not meassure Bit Error Rate eno: Invalid
argument (22)
>DVBSM(0), Warning: Can not count Uncorrected Blocks eno: Operation not
supported (95)
>DiSEqCDevTree, Error: Port 1 has no connected devices configured.
>DiSEqCDevTree, Error: Port 1 has no connected devices configured.
(...)
>DVBChan(2:0) Error: Tune(): Failed to setup DiSEqC devices
I've got Multiswitch "on the roof" - 1:Hotbird13 2:Astra19
I try change tone/diseq/legacy in capture cards menu but nothing...
Patched szap locks OK and I can write channels with cat...
--
Pozdrawiam!
Gasiu
_______________________________________________
mythtv-dev mailing list
mythtv-dev [at] mythtv
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev
|
