TSERONG at novell
Nov 10, 2009, 10:51 PM
Post #2 of 2
(491 views)
Permalink
|
>>> On 11/11/2009 at 05:08 PM, abhishek agrawal <agrawal.tech [at] gmail> wrote:
> I am trying to start a failover IP on a m/c . I m getting following error msg
>
>
> crmd[8153]: 2009/11/11_11:19:07 info: attrd_update: Sent update:
> probe_complete=true for localhost
> attrd[8152]: 2009/11/11_11:19:07 info: attrd_ha_callback: flush
> message from sit-dm-2.localdomain
> attrd[8152]: 2009/11/11_11:19:07 info: find_hash_entry: Creating hash
> entry for fail-count-rep_resource_10.1.1.177
> attrd[8152]: 2009/11/11_11:19:07 info: attrd_ha_callback: flush
> message from sit-dm-2.localdomain
> attrd[8152]: 2009/11/11_11:19:07 info: find_hash_entry: Creating hash
> entry for last-failure-rep_resource_10.1.1.177
> crmd[8153]: 2009/11/11_11:19:09 info: do_lrm_rsc_op: Performing
> key=15:6:0:2fc668c9-869a-4c06-ab08-c865373d27ce
> op=ip_resource15.154.59.160_start_0 )
> lrmd[8150]: 2009/11/11_11:19:09 info: rsc:ip_resource15.154.59.160: start
> lrmd[8150]: 2009/11/11_11:19:09 info: RA output:
> (ip_resource15.154.59.160:start:stderr) ERROR: Cannot use default
> route w/o netmask [15.154.59.160]
>
> IPaddr[8439]: 2009/11/11_11:19:09 ERROR: /usr/lib64/heartbeat/findif
> failed [rc=1].
> crmd[8153]: 2009/11/11_11:19:09 info: process_lrm_event: LRM operation
> ip_resource15.154.59.160_start_0 (call=7, rc=1, cib-update=18,
> confirmed=true) complete unknown error
>
> my network config is as follows:
> eth0 Link encap:Ethernet HWaddr 00:13:21:C9:5C:FF
> inet addr:15.154.59.15 Bcast:15.154.59.255 Mask:255.255.254.0
> inet6 addr: fe80::213:21ff:fec9:5cff/64 Scope:Link
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:459289 errors:0 dropped:0 overruns:0 frame:0
> TX packets:20878 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:53030356 (50.5 MiB) TX bytes:4138331 (3.9 MiB)
> Interrupt:217
>
> can someone help me out..what does findif do..and what can be the
> problem due to which it fails
findif tries to figure out which interface should be used for a given IP address. Check the output of "route -n" to see if there's anything weird-looking there, or try explicitly specifying a netmask or nic in the cidr_netmask or nic parameter for your IP address resource.
Regards,
Tim
--
Tim Serong <tserong [at] novell>
Senior Clustering Engineer, Novell Inc.
_______________________________________________
Linux-HA mailing list
Linux-HA [at] lists
http://lists.linux-ha.org/mailman/listinfo/linux-ha
See also: http://linux-ha.org/ReportingProblems
|
