mandzak.j at gmail
Nov 24, 2009, 3:49 AM
Post #1 of 1
(602 views)
Permalink
|
Hi, firstly sorry my english. :)
My pv250's tuner card is no voice of the default audio routing
settings,only if other value to give him. (ivtv-ctl -v
input=7,output=6). 2.6.28 kernel, worked as well. 2.6.31 kernel, but
does not work in the audio routing and claim no voice.
~$ ivtv-ctl -v input=7,output=6
ioctl VIDIOC_INT_S_AUDIO_ROUTING failed: Invalid argument
ivtvctl -v
01:0a.0 Multimedia video controller: Internext Compression Inc iTVC16
(CX23416) MPEG-2 Encoder (rev 01)
Subsystem: Hauppauge computer works Inc. Device 4009
Flags: bus master, medium devsel, latency 64, IRQ 16
Memory at d8000000 (32-bit, prefetchable) [size=64M]
Capabilities: <access denied>
Kernel driver in use: ivtv
Kernel modules: ivtv
dmesg
ivtv: Start initialization, version 1.4.1
ivtv0: Initializing card 0
ivtv0: Autodetected Hauppauge card (cx23416 based)
ivtv 0000:01:0a.0: PCI INT A -> Link[APC1] -> GSI 16 (level, high) ->
IRQ 16
tveeprom 2-0050: Hauppauge model 32059, rev B143, serial# 2764082
tveeprom 2-0050: tuner model is Temic 4046FM5 (idx 43, type 22)
tveeprom 2-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K)
(eeprom 0x74)
tveeprom 2-0050: audio processor is MSP4418 (idx 25)
tveeprom 2-0050: decoder processor is SAA7115 (idx 19)
tveeprom 2-0050: has no radio, has IR receiver, has no IR transmitter
ivtv0: Autodetected Hauppauge WinTV PVR-250
saa7115 2-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver
#0)
msp3400 2-0040: MSP4418G-A2 found @ 0x80 (ivtv i2c driver #0)
msp3400 2-0040: msp3400 supports nicam and radio, mode is autodetect and
autoselect
tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0)
tuner-simple 2-0061: creating new instance
tuner-simple 2-0061: type set to 22 (Temic PAL/SECAM multi (4046 FM5))
IRQ 16/ivtv0: IRQF_DISABLED is not guaranteed on shared IRQs
ivtv0: Registered device video0 for encoder MPG (4096 kB)
ivtv0: Registered device video32 for encoder YUV (2048 kB)
ivtv0: Registered device vbi0 for encoder VBI (1024 kB)
ivtv0: Registered device video24 for encoder PCM (320 kB)
ivtv0: Initialized card: Hauppauge WinTV PVR-250
ivtv: End initialization
ivtv 0000:01:0a.0: firmware: requesting v4l-cx2341x-enc.fw
ivtv0: Loaded v4l-cx2341x-enc.fw firmware (376836 bytes)
ivtv0: Encoder revision: 0x02060039
v4l2-ctl --log-status
[14423.447571] ivtv0: ================= START STATUS CARD #0
=================
[14423.447577] ivtv0: Version: 1.4.1 Card: Hauppauge WinTV PVR-250
[14423.497358] tveeprom 2-0050: Hauppauge model 32059, rev B143,
serial# 2764082
[14423.497362] tveeprom 2-0050: tuner model is Temic 4046FM5 (idx 43,
type 22)
[14423.497366] tveeprom 2-0050: TV standards PAL(B/G) PAL(I)
SECAM(L/L') PAL(D/D1/K) (eeprom 0x74)
[14423.497370] tveeprom 2-0050: audio processor is MSP4418 (idx 25)
[14423.497373] tveeprom 2-0050: decoder processor is SAA7115 (idx 19)
[14423.497376] tveeprom 2-0050: has no radio, has IR receiver, has no
IR transmitter
[14423.497384] ivtv0: GPIO status: DIR=0xdf00 OUT=0x26f3 IN=0x0009
[14423.497387] saa7115 2-0021: Audio frequency: 48000 Hz
[14423.509128] saa7115 2-0021: Input: Composite 4
[14423.509133] saa7115 2-0021: Video signal: bad
[14423.509135] saa7115 2-0021: Frequency: 50 Hz
[14423.509138] saa7115 2-0021: Detected format: BW/No color
[14423.509140] saa7115 2-0021: Width, Height: 720, 576
[14423.510504] msp3400 2-0040: msp3400 rev1 = 0x0117 rev2 = 0x1242
[14423.510507] msp3400 2-0040: Audio: volume 58880
[14423.510510] msp3400 2-0040: Standard: could not detect sound
standard (mono)
[14423.510513] msp3400 2-0040: Audmode: 0x0001
[14423.510516] msp3400 2-0040: Routing: 0x00000000 (input)
0x00000044 (output)
[14423.510519] msp3400 2-0040: ACB: 0x0c00
[14423.510523] tuner 2-0061: Tuner mode: analog TV
[14423.510526] tuner 2-0061: Frequency: 400.00 MHz
[14423.510528] tuner 2-0061: Standard: 0x0000000f
[14423.510532] ivtv0: Video Input: Tuner 1
[14423.510534] ivtv0: Audio Input: Tuner 1
[14423.510536] ivtv0: Tuner: TV
[14423.510540] ivtv0: Stream: MPEG-2 Program Stream
[14423.510543] ivtv0: VBI Format: No VBI
[14423.510546] ivtv0: Video: 720x576, 25 fps
[14423.510549] ivtv0: Video: MPEG-2, 4x3, Variable Bitrate, 6000000,
Peak 8000000
[14423.510553] ivtv0: Video: GOP Size 12, 2 B-Frames, GOP Closure
[14423.510557] ivtv0: Audio: 48 kHz, MPEG-1/2 Layer II, 224 kbps,
Stereo, No Emphasis, No CRC
[14423.510562] ivtv0: Spatial Filter: Manual, Luma 1D Horizontal,
Chroma 1D Horizontal, 0
[14423.510565] ivtv0: Temporal Filter: Manual, 8
[14423.510568] ivtv0: Median Filter: Off, Luma [0, 255], Chroma [0,
255]
[14423.510570] ivtv0: Status flags: 0x00200000
[14423.510574] ivtv0: Stream encoder MPG: status 0x0000, 0% of 4096
KiB (128 buffers) in use
[14423.510578] ivtv0: Stream encoder YUV: status 0x0000, 0% of 2048
KiB (64 buffers) in use
[14423.510581] ivtv0: Stream encoder VBI: status 0x0000, 0% of 1049
KiB (41 buffers) in use
[14423.510585] ivtv0: Stream encoder PCM: status 0x0000, 0% of 324
KiB (72 buffers) in use
[14423.510588] ivtv0: Read MPG/VBI: 0/0 bytes
[14423.510590] ivtv0: ================== END STATUS CARD #0
==================
What can I do to have a voice?
Thanks!
Joe
_______________________________________________
ivtv-users mailing list
ivtv-users [at] ivtvdriver
http://ivtvdriver.org/mailman/listinfo/ivtv-users
|
