Frank_Wakelin at yvr
Nov 27, 2009, 10:39 AM
Post #3 of 3
(749 views)
Permalink
|
Thanks Lelio (& Wes)! Worked perfectly.
_____
From: Lelio Fulgenzi [mailto:lelio [at] uoguelph]
Sent: Thursday, November 26, 2009 7:06 PM
To: Frank Wakelin
Cc: cisco-voip [at] puck
Subject: Re: [cisco-voip] CCM 4.1 - Hardware Conference Bridge
you can use the DSP calculator to tell you what you need.
www.cisco.com/go/tools (THANKYOU WES)
and select DSP calculator
plug in your 2x2mft ports, 96 calls and then see how many DSPs you need for
that.
then you can just keep adding conference calls until you get to 2xPVDM64
chips.
---
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
"Bad grammar makes me [sic]" - Tshirt
----- Original Message -----
From: "Frank Wakelin" <Frank_Wakelin [at] yvr>
To: cisco-voip [at] puck
Sent: Thursday, November 26, 2009 5:23:52 PM GMT -05:00 US/Canada Eastern
Subject: [cisco-voip] CCM 4.1 - Hardware Conference Bridge
Hi all,
We're migrating off of our 6500-based 6608s and migrating to a 3845. The
6608 was using 3x ports for T1 trunks to the telco and 2x ports as hardware
conference bridge. The 3845s have the following inventory:
* 2x "VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1
* 2x "PVDM2-64 - PVDMII DSP SIMM with four DSPs
So my question - are any of the DSP resources on this router available for
use as a replacement conference bridge? If so, can someone point me in the
right direction for configuring these?
Frank Wakelin
Senior Technical Analyst, Information Technology Services
VANCOUVER AIRPORT AUTHORITY
DIRECT: 604.303.4797 | FAX: 604.232.6198 | WWW.YVR.CA <http://www.yvr.ca/>
OFFICIAL AIRPORT OF THE VANCOUVER 2010 OLYMPIC AND PARALYMPIC WINTER GAMES
_______________________________________________ cisco-voip mailing list
cisco-voip [at] puck
https://puck.nether.net/mailman/listinfo/cisco-voip
|
attec737.jpg
smime.p7s
