ccietalk at gmail
Nov 18, 2009, 7:46 AM
Post #4 of 4
(848 views)
Permalink
|
Yeah if your controllers don't show up then try card-type.
On 11/18/09, Cumhur Kizilari <yahoo [at] cumhur> wrote:
> Dear Martin,
>
> Have you tried "card type e1" command ?
>
> Best Regards.
> Cumhur KIZILARI
>
>>
>>
>> On Wed, Nov 18, 2009 at 4:34 PM, CCIETalk.com <ccietalk [at] gmail> wrote:
>>
>>> Did you configure your controller E1?
>>>
>>> On 11/18/09, Martin Bufton <m.bufton [at] spectra-group> wrote:
>>> > Good afternoon.
>>> >
>>> >
>>> >
>>> > I need help with a PRI card, please.
>>> >
>>> >
>>> >
>>> > It is installed in a Cisco 3845 running C3845-SPServicesK9-M 12.4
>>> > (15)T9
>>> >
>>> > The card is a VWIC2-2MFT-T1/E1 installed in HWIC0
>>> >
>>> > I plan to use this as a MGCP gateway.
>>> >
>>> >
>>> >
>>> > I'm expecting to see the voice-ports in the configuration. but the
>>> running
>>> > configure doesn't show anything about the presence of the card.
>>> >
>>> >
>>> >
>>> > Show version reports "2 channelized (E1 or T1)/PRI ports"
>>> >
>>> >
>>> >
>>> > Thanks in advance
>>> >
>>> >
>>> >
>>> >
>>>
>>> --
>>> Sent from my mobile device
>>>
>>> www.ccietalk.com
>>> _______________________________________________
>>> cisco-voip mailing list
>>> cisco-voip [at] puck
>>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>>
>>
>>
>
--
Sent from my mobile device
www.ccietalk.com
_______________________________________________
cisco-voip mailing list
cisco-voip [at] puck
https://puck.nether.net/mailman/listinfo/cisco-voip
|
