sv at intelsoft
Nov 14, 2005, 11:52 PM
Post #1 of 1
(36 views)
Permalink
|
|
cisco AP 1300 and length of wep key
|
|
Hi
I intend to use cisco AP 1300 ( IOS 12.3(7)JA1) in my network, but I have problem with client who has
old wi-fi pcmcia card (it support only wep 40bit)
my config is
dot11 ssid is_client
vlan 30
authentication open eap eap_methods
authentication network-eap eap_methods
guest-mode
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption vlan 30 mode ciphers wep40
!
ssid is_client
my new Macintosh computer works fine (it use LEAP), but my windows and linux box auth successfully,
but can't ping anything(it uses PEAP-MS-CHAP-v2 and EAP-TLS), as I discovered problem that AP sent
128bit key instead of 40bit to my old client
eth1 IEEE 802.11b ESSID:"is_client" Nickname:"HERMES I"
Mode:Managed Frequency:2.432 GHz Access Point: 00:13:1A:4B:AE:50
Bit Rate:2 Mb/s Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:1002-6F87-BF8C-C7A2-1016-9450-AF [4] Security mode:open
Power Management:off
Link Quality=33/92 Signal level=-60 dBm Noise level=-93 dBm
Rx invalid nwid:0 Rx invalid crypt:8588 Rx invalid frag:1
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
why?
_______________________________________________
cisco-nsp mailing list cisco-nsp[at]puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
|
