eh at solnet
May 24, 2012, 2:13 AM
Views: 1074
Permalink
|
|
Re: Lot of input errors on a NPE-G1 interface
[In reply to]
|
|
Hi
After the port-fast discussion back to your original question. The first
thing to look is the interface controller (show controller , show ip
interface) and the logging to make sure I don't have speed/duplex or
flow-control problems.
Second you get "unknown protocol drops" this happens mostly from cdp
packets. You send cdp from your switch but drop them on your router.
I my case I had to enable flow-control on my 3560 switch and allow pause
frames from the npe-g1. Hint: Sometimes it is more reliable to turn the
auto-neg feature off
Regards
Erich
>
> NPE-G1:
> ------------
> GigabitEthernet0/1 is up, line protocol is up
> Hardware is BCM1250 Internal MAC, address is 0006.52f4.d81b (bia
> 0006.52f4.d81b)
> Internet address is x.x.x.x/28
> MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
> reliability 255/255, txload 1/255, rxload 1/255
> Encapsulation ARPA, loopback not set
> Keepalive set (10 sec)
> Full-duplex, 1000Mb/s, link type is autonegotiation, media type is SX
> output flow-control is XON, input flow-control is XON
> ARP type: ARPA, ARP Timeout 04:00:00
> Last input 00:00:00, output 00:00:00, output hang never
> Last clearing of "show interface" counters never
> Input queue: 0/75/1321/1 (size/max/drops/flushes); Total output drops: 0
> Queueing strategy: fifo
> Output queue: 0/40 (size/max)
> 5 minute input rate 4264000 bits/sec, 871 packets/sec
> 5 minute output rate 5859000 bits/sec, 1597 packets/sec
> 27479327 packets input, 3434822229 bytes, 0 no buffer
> Received 941 broadcasts, 0 runts, 0 giants, 0 throttles
> 989 input errors, 0 CRC, 0 frame, 989 overrun, 0 ignored
> 0 watchdog, 17119 multicast, 0 pause input
> 0 input packets with dribble condition detected
> 43616309 packets output, 2243854018 bytes, 0 underruns
> 5 output errors, 0 collisions, 4 interface resets
> 561 unknown protocol drops
> 0 babbles, 0 late collision, 0 deferred
> 5 lost carrier, 0 no carrier, 0 pause output
> 0 output buffer failures, 0 output buffers swapped out
_______________________________________________
cisco-nsp mailing list cisco-nsp [at] puck
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
|
