gaurav at inwire
Mar 2, 2007, 12:07 AM
Post #1 of 1
(1774 views)
Permalink
|
|
[Fwd: C876 - Forced to use NAT Virtual Interface]
|
|
Had sent this to c-nsp and got no response. Hopefully something from here.
-------- Original Message --------
Subject: C876 - Forced to use NAT Virtual Interface
Date: Wed, 28 Feb 2007 10:29:10 +0100
From: Gaurav Sabharwal <gaurav [at] inwire>
To: cisco-nsp [at] puck
Have a Cisco 876 router running 12.4(6)T6 IOS release and have noticed
that classic NAT translation does not works. Below is the relevant
configuration.
!
interface Virtual-PPP1
ip address negotiated
ip nat outside
ip virtual-reassembly
fair-queue
no cdp enable
ppp authentication chap callin
ppp chap hostname testuser
ppp chap password 0 testpass
ppp direction callout
pseudowire 172.17.101.1 10 pw-class pwclass1
!
interface Vlan1
ip address 192.168.10.1 255.255.255.128
ip nat inside
ip virtual-reassembly
!
ip nat source static 192.168.10.1 10.10.0.17
ip nat source static 192.168.10.2 10.10.0.18
ip nat source static 192.168.10.3 10.10.0.19
ip nat source static 192.168.10.4 10.10.0.20
!
show classic NAT statistics
rtr# sh ip nat stat
Total active translations: 0 (0 static, 0 dynamic; 0 extended)
Outside interfaces:
Dialer1, Virtual-Access1
Inside interfaces:
Vlan1
Hits: 0 Misses: 0
CEF Translated packets: 0, CEF Punted packets: 0
Expired translations: 0
Dynamic mappings:
Queued Packets: 0
rtr# show ip nat stat
Total active translations: 0 (0 static, 0 dynamic; 0 extended)
Outside interfaces:
Dialer1, Virtual-Access1
Inside interfaces:
Vlan1
Hits: 0 Misses: 0
CEF Translated packets: 0, CEF Punted packets: 0
Expired translations: 0
Dynamic mappings:
Queued Packets: 0
show stats for NVI
rtr# sh ip nat nvi stat
Total active translations: 4 (4 static, 0 dynamic; 0 extended)
NAT Enabled interfaces:
Hits: 0 Misses: 0
CEF Translated packets: 0, CEF Punted packets: 0
Expired translations: 0
Dynamic mappings:
rtr# show ip nat nvi trans
Pro Source global Source local Destin local Destin global
--- 10.10.0.17 192.168.10.1 --- ---
--- 10.10.0.18 192.168.10.2 --- ---
--- 10.10.0.19 192.168.10.3 --- ---
--- 10.10.0.20 192.168.10.4 --- ---
Reading the documents, my understanding is that the NVI interface will
be triggered when "ip nat enable" command is used on the interfaces.
Anybody seen this issue or point the obvious thing that I am missing in
the configuration?
Thanks,
- Gaurav
_______________________________________________
cisco-bba mailing list
cisco-bba [at] puck
https://puck.nether.net/mailman/listinfo/cisco-bba
|
