frnkblk at iname
Jan 13, 2011, 3:11 PM
Post #1 of 1
(934 views)
Permalink
|
|
Re: Specify PPPoE Virtual-Access Interface bandwidth on LNS via RADIUS/AAA
|
|
This thread may help:
http://www.gossamer-threads.com/lists/cisco/nsp/44608
Frank
-----Original Message-----
From: cisco-bba-bounces [at] puck
[mailto:cisco-bba-bounces [at] puck] On Behalf Of Gary T. Giesen
Sent: Wednesday, January 12, 2011 9:31 AM
To: cisco-bba [at] puck
Subject: [cisco-bba] Specify PPPoE Virtual-Access Interface bandwidth on LNS
via RADIUS/AAA
Is there any way to specify the bandwidth on virtual-access interfaces
(to be used for OSPF, QoS, etc) via RADIUS/AAA? I'm currently using
"lcp:interface-config=bandwidth 4032\nbandwidth receive 800".
Here's what I see:
#show int vi4
Virtual-Access4 is up, line protocol is up
Hardware is Virtual Access interface
Interface is unnumbered. Using address of Loopback64757 (172.23.254.254)
MTU 1492 bytes, BW 155520 Kbit/sec, RxBW 800 Kbit/sec, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Open
Open: IPCP
PPPoVPDN vaccess, cloned from AAA, Virtual-Template1
#show ip ospf interface vi4
Virtual-Access4 is up, line protocol is up
Interface is unnumbered. Using address of Loopback64757
(172.23.254.254), Area 0
Process ID 64757, Router ID 172.23.254.254, Network Type
POINT_TO_POINT, Cost: 24
Topology-MTID Cost Disabled Shutdown Topology Name
0 24 no no Base
You can see the cost for OSPF is 24 (100/4.032 ~=24) so OSPF is
picking it up, but I'm curious why it's not showing up on the
interface itself. I'm also in the process of implementing QoS as well,
though I haven't yet tested if the QoS but obviously it'll need to
know the proper value...
GG
_______________________________________________
cisco-bba mailing list
cisco-bba [at] puck
https://puck.nether.net/mailman/listinfo/cisco-bba
_______________________________________________
cisco-bba mailing list
cisco-bba [at] puck
https://puck.nether.net/mailman/listinfo/cisco-bba
|
